Jamma Harness "Necks"

Ideal for making Jamma Adapters

Portion of a used Jamma harness ideal for making Jamma adapters for circuit boards.  This is the Jamma edge connector along with about 6" of the wiring cut off cleanly.  We use these in the shop to make Jamma adapters, usually need to move a couple of wires, but eliminates the need to wire the Jamma side of the adapter, just crimp or solder the cut end of the wires to the mapping for the board you are making an adapter.

Listing is for one "Jamma Harness Neck", picture shows a couple to give you an idea of what to expect.